The SI1145 is a new sensor from SiLabs with a calibrated UV sensing algorithm that can calculate UV Index. We took this outside a couple days and compared the calculated UV index with the news-reported index and found it was very accurate! It’s a digital sensor that works over I2C so just about any microcontroller can use it. The sensor also has individual visible and IR sensing elements so you can measure just about any kind of light – we only wrote our library to printout the ‘counts’ rather than the calculate the exact values of IR and Visible light so if you need precision Lux measurement check out the TSL2561. If you’re feeling really advanced, you can connect up an IR LED to the LED pin and use the basic proximity sensor capability that is in the SI1145 as well.
We wrapped this nice little sensor up on a PCB with level shifting and regulation circuitry so you can safely use it with 3 or 5V microcontrollers. Each order comes with one fully assembled and tested PCB breakout and a small piece of header. You’ll need to solder the header onto the PCB but it’s fairly easy and takes only a few minutes even for a beginner.
Features:
- Features SI1145 Chipset
- Digital i2c Sensor, with Level shifting for 3V & 5V Microcontrollers.
- Works with the Raspberry Pi & Arduino
- Senses Visible, IR & UV Light
- Basic Proximity Sensing – Just connect an IR LED to the LED pin
- IR Sensor Spectrum: Wavelength: 550nm-1000nm (centered on 800nm)
- Visible Light Sensor Spectrum: Wavelength: 400nm-800nm (centered on 530nm)
- Voltage Supply: Power with 3-5VDC
- Output Type: I2C address 0x60 (7-bit)
- Operating Temperature: -40°C ~ 85°C
Reviews
There are no reviews yet.