ACS712 20A (Current Sensor Module)
Product Description:
- AC / DC 20A Current Sensing Module ACS712
- 100 mV/A output sensitivity
- 5. 0 V, single supply operation
- Output voltage proportional to AC or DC currents
- Factory-trimmed for accuracy
- Extremely stable output offset voltage
- Nearly zero magnetic hysteresis
- Ratiometric output from supply voltage
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- 80 kHz bandwidth
- Total output error 1.5% at TA = 25°C
- 1.2 mΩ internal conductor resistance
Description:
ACS712 20A Current Sensor is a current sensing board based on Allegro’s ACS712 magnetic linear current sensor IC. ACS712 can sense current up to bidirectional 20A with lower than 5% error. The sensor’s output is analog voltage(100mV/A).
ACS712 20A Current Sensor uses hall effect while sensing current Because of that it can be easily used in applications that require electronic isolation. The filter pins on the board can be used to adjust the bandwidth (80kHz default) by connecting a capacitor.
General Specifications:
- Bidirectional current sensing up to 20A
- Electronic isolation by hall effect
- Adjustable bandwidth
- Wide operating temperature range
Technical Specifications:
- Operating Voltage: 3-5V
- Internal Resistance: 1.2mΩ
- Operating Temperature: -40⁰C – 85⁰C
- Weight: 1g
You must be logged in to post a review.
Related products
DHT22- (Temperature and humidity sensor)
Product description:
The DHT22 module is designed to measure the temperature and humidity of the atmosphere. The difference from the younger model (DHT11), The DHT22 has a wide range and a high precision determination of temperature and humidity. The sensor works on the OneWire bus, which makes it possible to connect it to the Arduino only three wires ( two of which are POwer supply). Low power consumption allows you to install it on stand-alone devices.
MQ-2 (Smoke sensor-HBO, LPG, Alcohol, Propane, Hydrogen, Methane and Carbon Monoxide)
- MQ-2 Gas Sensor Module LPG, Smoke, Alcohol, Propane, Hydrogen, Methane and Carbon Monoxide Detection
- Dual signal output (analog output, and TTL level output)
- The gas, natural gas, city gas, smoke better sensitivity
- With a long service life and reliable stability
- Rapid response and recovery characteristics
SHT31 (Digital Temperature and Humidity Sensor Module)
- Highly reliable, accurate and quick response time
- I2C interface
- Well calibrated, linearized, compensated for digital output
- Highly abstracted development library
- Input voltage (VCC): 3.3 volts or 5 volts
- I/O Logic Level : 3.3 volts or 5 volts based on VCC
- Operating Current : 100 μA
- Operating Temperature : -40–125 ℃
- Temperature Sensor Range : -40–125 ℃, with ±0.3°C accuracy
- Humidity Sensor Range : 0% - 100%(Relative Humidity), with ±2% accuracy
- Sensor Chip : SHT31
- I2C
TCS34725 (RGB Color Sensor with IR filter and White LED)
Reviews
There are no reviews yet.