AVR Board UNO PLUS Onboard MCU ATMEGA328P-AU Compatible with Arduino UNO R3 Board Kit Improved & Enhanced Solution Development Board
AVR Board UNO Plus Onboard MCU Atmega328P-AU Compatible With Arduino
Overview:
- Compatible with Arduino UNO R3
- improved & enhanced alternative solution for Arduino UNO R3
- compatible with standard Arduino interface with an additional analog input (A6)
- solder pads provided, supports prototype breadboard
- ICSP interface
Description
Reviews (0)
Be the first to review “AVR Board UNO Plus Onboard MCU Atmega328P-AU Compatible With Arduino” Cancel reply
You must be logged in to post a review.
Shipping & Delivery
Related products
(OV5647) Raspberry Pi Night Vision Camera Module
Arduino MEGA 2560 R3 (ATMEGA2560-16AU MCU)
Overview
The Arduino Mega 2560 is a microcontroller board based on the ATmega2560 (datasheet). It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. The Mega is compatible with most shields designed for the Arduino Duemilanove or Diecimila.Arduino Pro Mini Atmega168 (3.3V/ 8MHz, 5V/16MHz)
Features:
- 14 Digital input / output ports RX, TX D13, D12
- 8 analog input port A0 to A7
- The TTL level serial transceiver port RX / TX
- 4.6 PWM ports, D3,, D5 , D6, D9, D10, D11
- Using Atmel Atmega168P microcontroller
- Supports serial download (TTL)
- Support for external 5V ~ 12V DC power supply
- Support 9V battery-powered
- clock frequency 16MHz
Package includes:
- 1x Arduino Pro mini Atmega168 module board
- 3x header pin rows
Arduino UNO R3 ATmega328P CH340G Development Board (SMD)
Mega2560 + WiFi R3 ATmega2560+ESP8266 | 32Mb Memory | USB-TTL CH340G | Compatible for Arduino Mega NodeMCU WeMos Development board
Raspberry Pi Compute Module 3 – 4Gbytes eMMC Flash
Raspberry Pi Calculation Module 3
Raspberry Compute Module 3 is for designers who prefer Raspberry Pi3 functionality but require a smaller form factor (67.6 mm X 31 mm) for their embedded design. These modules are DDR2-SODIMM, mechanically compatible system-on-a-chip (SoM) that includes a BCM2837 processor system-on-a-chip (SoC) with 1 GB of LPDDR2 RAM and 4 GB of eMMC flash. In addition, these modules have an additional input/output (I/O) interface in addition to the Raspberry Pi Model A/B board.
SIMCom- SIM900-DS
WiFly RN-171
Features:
- Ultra low power for battery powered applications
- Firmware configurable transmit power: 0dBm to +12dBm
- Hardware interfaces: UART
- Supports Adhoc and infrastructure networking modes
- User programmable GPIO & ADCs
- Real-time clock for time-stamping, auto-sleep, and auto-wakeup modes
- Run directly from batteries or regulated power supplies
- Configuration over serial or wireless interface using simple ASCII commands
- Over the air firmware upgrade
- Secure Wi-Fi authentication schemes (WEP/WPA/WPA2)
- Full onboard TCP/IP stack (no external drivers required)
Reviews
There are no reviews yet.