Modules Archives - Page 5 of 11

The camera V3 module is specifically designed for the BPI-M3. It includes CMOS sensor module OV5640 (5M Pixel)

OV5640 banana chip pi similar camera for raspberry pi csi camera
Banana pi camera, use ov5640 (500w) chip inside

CC3000 WiFi Shield for Arduino

Modules, Arduino Sheilds

CC3000 is a fully-equipped wireless network processor, which simplifies the execution of Internet connectivity . SIMPLELINK WIFI can greatly reduce the host microcontroller (MCU) software requirements , making use of any low-cost and low- power MCU embedded applications can be the ideal solutionWireless Network Processor : IEEE802.11b / g Embedded IPV4TCP/IP stack The radio industry\’s best performance: Tx Power : 11MBPSj for +18 DBM, CCK RX Sensitivity :-86DBM, 8% packet error rate (PER), 11MBPS Memory package with a compact , low processing millions of instructions every second (MIPS), low-cost microcontroller to work together : 2K Bytes Flash 250 bytes of RAM Operating temperature range : -20 to 70 degrees

DC-DC Buck Regulator XL4015 adjustable step-down module 4~38VDC-5A

Modules, Development Boards

Introduction:

The XL4015 power module is a DC to DC step-down (BUCK) power module that operates at a switching frequency of 180kHz. In such high frequency, it provides smaller sized filter components compared with low frequency switching regulators.

Module Highlights:

5A high-power
high- efficiency
low-ripple
power indicator
heat sink

ELET114A Bluetooth dual-mode transmission serial port BT4.0 Module For iOS and Android

Modules, Bluetooth

The integrated MCU module and Bluetooth chip, support UART, SPI, I2C and interfaces I2S, including 4 PWM ports and 6 12bit ADC channels, with high integration, low cost, low power consumption, excellent performance of Bluetooth radio.

ESP-01 ESP8266 serial WIFI wireless module (Upgraded version) Wireless Transceiver ESP8266-01

Modules, Development Boards

Introduction:

High quality & low price
LWIP agreement
Support 3 modes: AP, STA, AP+STA
Perfect and simple AT commands

Now Arduino can get on WiFI without breaking the bank. Use this module for your next Internet of Things (IoT) project, home automation, Or remote sensor project. This module adopts the ESP8226 IC for use over a serial connection using simple AT commands. No SPI interface or Know-How is required.

ESP-WROOM-32 Development Board | 2.4GHz Dual-Mode WiFi + Bluetooth Dual Cores Microcontroller Processor With built-in Antenna

Modules, Bluetooth

2.4GHz Dual-Mode WiFi + Bluetooth Development Board
Ultra-Low power consumption works perfectly with the Arduino IDE
Support LWIP protocol, Freertos
SupportThree Modes: AP, STA, and AP+STA
ESP32 is safe, reliable, and scalable to a variety of applications
30Pin ESP32 Development Board 2.4GHz WiFi Dual Cores Microcontroller Integrated with Antenna RF Low Noise Amplifiers Filters

ESP32-CAM WiFi + bluetooth Camera Module Development Board ESP32 With Camera Module OV2640

Modules, Development Boards

Introduction:

The ESP32-CAM has a very competitive small-sized camera module that can operate independently as a minimum system.ESP32-CAM can be widely used in various IoT applications. It is suitable for home smart devices, industrial wireless control, wireless monitoring, QR wireless identification, wireless positioning system signals, and other IoT applications.ESP32-CAM is packaged in DIP and can be directly plugged into the backplane for quick production. It provides customers with a highly reliable connection method and is convenient for use in various IoT hardware terminals.

ESP8266 ESP-05 Remote Serial Port WiFi Transceiver Wireless Module

Modules, WiFi Module

This ESP8266 ESP-05 Serial WIFI Module is based on ESP8266 SoC. The SOC has Integrated TCP/IP protocol stack which is TTL serial communication interface and its parameters can be set by AT command.

ESP8266 ESP-12E UART Wi-Fi Shield for Arduino UNO & MEGA

Modules, WiFi Module

Fully compatible with Uno, Mega, etc. using standard pin interface spacing .(unless standard size, such as Nano, Mini)

ESP8266 ESP-12F WiFi module

Modules, WiFi Module

The module has the ability to run independent of a host controller.The ESP8266 Serial/UART to WiFi module is a great way to connect your Arduino or other microcontroller projects to a WiFi network.You can proceed to create your next internet of things (IOT) project with affordable network connectivity by implementing this module into your design.The ESP8266 has 3.6V max tolerant I/Os so you will need a logic level converter to connect it with higher voltage devices such as Arduino.The ESP8266 requires 3.3V power so you may need a 3.3V voltage regulator to provide the correct voltage, depending on your setup.

ESP8266 ESP-201 Remote Serial Port WiFi Transceiver Wireless Module

Modules, WiFi Module

This ESP-201 module is one of the ESP8266 board version. This ESP8266 support both pcb antenna and external antenna using U.FL connector. ESP-201 comes with Ai-Thinker firmware as they are the 3rd party manufacture of Espressif chip. With a dimension of 25mm x 35mm, this board required de-soldering and soldering modification of middle pins to make sure it is breadboard friendly.

ESP8266 NodeMCU Lua WiFi Development Board

Modules, WiFi Module

The NodeMcu is an open-source firmware and development kit that helps you to Prototype your IOT product within a few Lua script lines.

Generals:

The Development Kit based on ESP8266, integates GPIO, PWM, IIC, 1-Wire and ADC all in one board.
Power your developement in the fastest way combinating with NodeMCU Firmware!
USB-TTL included, plug&play
10 GPIO, every GPIO can be PWM, I2C, 1-wire
FCC CERTIFIED WI-FI module（Coming soon）
PCB antenna

Add to wishlist

Add to cart

Quick view