Description:
Because the Arduino Pro mini and Arduino Mini USB Adapter are separate, there is no reset circuit on Arduino pro mini. So there sometimes may happen this accident like yours.
There is an skilled way :
First holding the reset button, then release reset button immediately when the LED of TX RX first flashing, and then you can download the code to your Arduino pro mini smoothly.
The Arduino Pro Mini is a microcontroller board based on the ATmega168 (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, an on-board resonator, a reset button, and holes for mounting pin headers. A six pin header can be connected to an FTDI cable or Sparkfun breakout board to provide USB power and communication to the board.
The Arduino Pro Mini is intended for semi-permanent installation in objects or exhibitions. The board comes without pre-mounted headers, allowing the use of various types of connectors or direct soldering of wires. The pin layout is compatible with the Arduino Mini.
There are two versions of Pro Mini :
One runs at 3.3V and 8 MHz
The other at 5V and 16 MHz
And this item is Arduino 3.3V/8 MHz Version Pro Mini With Atmega168
It’s blue ad black! It’s thin (0.8mm)! It’s the Arduino Pro Mini! SparkFun’s minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz bootloader (select ‘Arduino Duemilanove w/ 168’ within the Arduino software). Arduino Pro Mini does not come with connectors populated so that you can solder in any connector or wire with any orientation you need. We recommend first time Arduino users start with the Duemilanove. It’s a great board that will get you up and running quickly. The Arduino Pro series is meant for users that understand the limitations of system voltage (3.3V), lack of connectors, and USB off board.
We really wanted to minimize the cost of an Arduino. The Arduino Pro Mini is like the Arduino Mini (same pin out) but to keep the cost low, we used all SMD components, made it two layer, etc. Connect the mini pro to your pc using the Arduino usb-serial.
Parameter :
Operating Voltage 3.3V
Input Voltage 3.35 -12 V
Digital I/O Pins 14 (of which 6 provide PWM output)
Analog Input Pins 6
DC Current per I/O Pin 40 mA
Flash Memory 16 KB (of which 2 KB used by bootloader)
SRAM 1 KB
EEPROM 512 bytes
Clock Speed 8 MHz
Features:
* ATmega168 (16K) running at 8MHz with external resonator (0.5% tolerance)
* USB connection off board
* Supports auto-reset
* 3.3V regulator
* Max 150mA output
* Over current protected
* Reverse polarity protected
* DC input 3.3V up to 12V
* On board Power and Status LEDs
Dimensions:
* 0.7×1.3″ (18x33mm)
* Less than 2 grams
Reviews
There are no reviews yet.